Both series have the option for corner trimming (corner rounding) and R scraping (radius scraping). Can be equipped with most operative groups and can have spray cleaning and spray release functions as an option turning it in to a highly speciﬁed machine for any edgebanding need.
The EV680 series have quick melts glue pots with Infrared heating. Optional quick change edge-bands available.
EDGEBANDING FUNCTIONS EXPLAINED
Spray release is used to clean the panel from dust and debris before the panel is edgebanded
Pre milling the panel with diamond tipped tools gives an extremely smooth edge prior to gluing
Glue pot for hot melt beads to bond edgeband to panel
Quick Melt Gluing
Quick Melt glue pot speeds up processing as the glue heats up rapidly, useful when frequent glue colour changes are required
Used with quick melt system to preheat the panel for rapid processing
6 Pressure Rollers
One big roller and 5 smaller rollers make sure the edge is pressed seamlessly against the edge
of the workpiece.
Rough & Fine Trimming
Rough trimming of the excess edge before fine trimming, used with thicker bands over 1.5mm
Fine trimming of edge before scraping.
Trims the edge band at the front end and back end of the panel
Corner Trimming (corner rounding)
Trims the 90 degree corner with a radius
R Scraping Station
Rough and fine scraping station prior to flat scraping for zero glue line edges
Final flat scraping to remove any tiny glue or edge particles prior to buffing
Spray cleaning unit cleans any dust residue from the trimming process prior to buffing
The buffing station rollers polish the machined top and bottom of edge of the panel
to give a perfectly clean and polished finish
Support tray for holding the edgebanding material waiting to be processed
All the operations available at your finger tips through the intuitive touchscreen user
The pressure conveyor holds the workpiece firmly in place whilst traversing through
the edgebanding machine
Adjustable roller support for supporting different size panels as they are processed through the machine
A device used to trim the scrap edgeband during the trimming process to prevent
wrapping around the milling tools.
|MACHINE DIMS LxWxHmm||5330 x 1000 x 1600||6460 x 1000 x 1600||6730 x 1000 x 1600||7640 x 1000 x 1600|
|MIN. WORKPIECE LENGTH||150mm|
|MIN. WORKPIECE WIDTH||60mm|
Gluing unit- End Trimming- Rough Trimming- Fine Trimming-Corner Trimming- Flat Trimming- Buffing
Pre Milling-Gluing unit- End Trimming- Rough Trimming-Fine Trimming-Corner Trimming- R Scraping- Offcut-Flat Trimming- Buffing
Please fill out the form below to request a brochure
Please fill out the form below to request finance
Please fill out the form below to raise a ticket with our support team