EDGEBANDING FUNCTIONS EXPLAINED

Spray Release
Spray release is used to clean the panel from dust and debris before the panel is edgebanded

Pre Milling

Pre milling the panel with diamond tipped tools gives an extremely smooth edge prior to gluing

Gluing Station

Glue pot for hot melt beads to bond edgeband to panel

Quick Melt Gluing

Quick Melt glue pot speeds up processing as the glue heats up rapidly, useful when frequent glue colour changes are required

Infrared Heating

Used with quick melt system to preheat the panel for rapid processing

6 Pressure Rollers

One big roller and 5 smaller rollers make sure the edge is pressed seamlessly against the edge
of the workpiece.

Rough & Fine Trimming

Rough trimming of the excess edge before fine trimming, used with thicker bands over 1.5mm
Fine trimming of edge before scraping.

End Trimming

Trims the edge band at the front end and back end of the panel

Corner Trimming (corner rounding)

Trims the 90 degree corner with a radius

R Scraping Station

Rough and fine scraping station prior to flat scraping for zero glue line edges

Flat Scraping

Final flat scraping to remove any tiny glue or edge particles prior to buffing

Spray Cleaning

Spray cleaning unit cleans any dust residue from the trimming process prior to buffing

Buffing Station

The buffing station rollers polish the machined top and bottom of edge of the panel
to give a perfectly clean and polished finish

Edgeband Tray

Support tray for holding the edgebanding material waiting to be processed

Delta Controller

All the operations available at your finger tips through the intuitive touchscreen user
interface

Pressure Conveyor

The pressure conveyor holds the workpiece firmly in place whilst traversing through
the edgebanding machine

Adjustable Support

Adjustable roller support for supporting different size panels as they are processed through the machine

Off Cut

A device used to trim the scrap edgeband during the trimming process to prevent
wrapping around the milling tools.